Rb-sc1 sample rate converter

Three LEDs above the button illustrate which source is selected. The 'SYNC' button allows the user to cycle through the synchronisation modes. The LEDS around the button display which mode has been selected. The rear panel has two groups of connectors providing inputs and outputs for channels one and two respectively.

The aperture for the BNC connector of optional video sync boards is capped. The serial port connector is a 9-pin D-sub types. Power is connected by an IEC inlet. Sample frequencies: 32, Dimensions WxDxH : x x 42mm, 1U.

Weight: 1. Included accessories: Manual, AC power cable. They can be used to synchronise the outputs to a 48kHz sample rate.

Would you like to use Canford's German website? This site uses cookies to store information on your computer. The The RB-LI2 stereo line isolation unit is used to isolate audio signals from inter-area ground hum loops, which could be caused by equipment being powered by different mains power supplies, or different phases on the same supply. The input and output are connected together through a transformer, which has internal jumpers allowing the outputs [more].

The RB-PLI6 passive line isolation unit is used to isolate audio signals from inter-area ground hum loops, which could be caused by equipment being powered by different mains power supplies or phases on the same supply. The input and output are connected together through a transformer, and the unit has internal jumpers allowing the inputs [more].

Ideal for the transfer of digital audio between different digital equipment, the RB-SC1 sample rate converter standardises the sample rate of a digital audio signal to one of 32kHz, There are four modes of operation of the RB-SC1 dependent on how you want to synchronise the output to the input :. In this mode the digital output sample rate is simply set by, and locked to, the internal on-board clock generator.

No sync signal is used or required. In this mode the digital output sample rate follows the sync input. When the sync signal is not present the output sample rate will be set by, and locked to, the internal on-board clock generator at a frequency determined by the switch position. In this mode no output will be generated until lock is achieved with a sync signal.